![]() If anyone can help me I'll be very thankful. and write the code outside of it the code works perfectly !īut i must use the clock in order to get this code work just on load = 1. Line 46: Instantiation is not allowed in sequential area except checker instantiation Line 37: Instantiation is not allowed in sequential area except checker instantiation Line 36: Instantiation is not allowed in sequential area except checker instantiation Line 34: Procedural assignment to a non-register product is not permitted, left-hand side should be reg/integer/time/genvar Line 35: Instantiation is not allowed in sequential area except checker instantiation The problem is that I get a lot of errors from the lines inside the condition if(load = 1) 8-bit unsigned multiplier using radix-4 modified booth algorithm and three 4-bit Carry-Lookahead-Adders. HA HA3(product,x15,x2,(inp1&inp2)) įA FA5(x14,x16,x4,(inp1&inp2),x15) įA FA4(x13,x17,圆,(inp1&inp2),x16) For the purpose of this project, I have implemented 6 different multipliers as follows: 8-bit signed (2’s complement) multiplier using radix-4 modified booth algorithm and two 4-bit Carry-Lookahead-Adders. Module multiply4bits(product,inp1,inp2,clock,reset,load) I'm trying to create a modules that simulates 4-bit multiplier without using multiplication (*), need just to use Half and Full adders, so I succeeded to program the solution from some instance, this is the code : module HA(sout,cout,a,b)
0 Comments
Leave a Reply. |